Brandmotion 1008-6502 - Manual

INSTALLATION INSTRUCTIONS
6501 and 6502 Instructions 6-13-12 1 of 20
Rear Vision System – Tailgate Handle Camera Aftermarket Display
2004-Current Ford F-150 and 2008-Current Ford Super Duty
(Kit part numbers 1008-6501 and 1008-6502)
Kit Contents: Tools Required:
Tailgate Handle with Camera
Chassis Harness with RCA (Note: In some cases a
RCA extension may be required to connect to
your aftermarket display. Kit# 6111 can be
purchased at Brandmotion for these cases.)
1 bag containing:
2 Templates (along with these instructions)
T30 Torx Driver
8mm and 10mm Sockets
Flat Head Screwdriver
Phillips Screwdriver
Plastic Trim Removal tool
Drill Bit (if needed)
1 inch Center Hole Saw
Soldering Iron
Small brush
Round file (if needed)
Deburring Tool
Corrosion Inhibitor (recommended)
Wire Ties (recommended)
NOTE: We strive to provide accurate and up-to-date installation instructions. The latest full color
instructions, as well as an installation video by viewing relevant portions of the full mirror kit (part
number 1008-9520) can be accessed at www.brandmotion.com
PRE-INSTALLATION VEHICLE CHECKLIST
Before beginning, determine how the vehicle is equipped and check appropriate boxes:
Determine whether the vehicle has an opening in the center of pickup bed close to opposite of the opening in the
bottom of the tailgate.
Yes, skip Section 1.
No, tailgate must be removed to drill an opening for the camera harness (refer to Section 1).
Check kit contents are complete against the list above.
TABLE OF CONTENTS
Pages
Section 1: Cut Pickup Bed Opening (if required) 2
Section 2: Camera Installation 3
Section 3: Chassis Harness Installation 4-6
Section 4: Wiring for Aftermarket Display 7-11
Section 5: Reference
5A: Supplied Camera and Chassis Harness Pinouts 12
5B: Previous Model Year Ignition & Reverse Locations 13-20