Brandmotion 9002-6500-V2 - Manual

INSTALLATION
INSTRUCTIONS
6500 Instructions 12-15-12.doc Page 1 of 10
Rear Vision System – Aftermarket Display
2007-Current Tahoe/Yukon/Suburban (Kit part numbers 9002-
6500)
Kit Contents:
Chassis Harness with RCA (Note: In some
cases a RCA extension may be
required to connect to your
aftermarket display. Kit# 6111 can be
purchased at Brandmotion.)
1 bubble bag containing Camera Mount
with Camera and Camera Harness
1 bag containing:
12 Wire Ties
2 Well Nuts
2 Bolts
2 Small Phillips Screws
ZTech (in a white bottle)
1 bag containing:
1 Template (along with these instructions)
Tools Required:
T30 Torx Driver
10mm and 28mm Sockets
10mm Open End Wrench
Pick
Push Pin Removal Tool
Phillips and Flat Blade Screwdrivers
Plastic Trim Removal Tool
Transfer Punch
1/8” and 5/16” Drill Bits
3/4” Drill Bit, Center Hole Saw, or Sheet
Metal Cutter
Power Drill
Deburring Tool
Electrical Tape
Note: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video (by viewing the relevant portions of the full mirror
installation video, kit number 1013-9530), please visit
www.brandmotion.com .
IMPORTANT: Before beginning kit installation, verify kit contents are complete against list above.
INSTALLATION
INSTRUCTIONS
Preparation
1. Ensure all lamps and accessories are OFF.
2. Ensure ignition switch is in the OFF position.
3. Loosen negative battery cable bolt. Remove
negative battery cable from terminal and position
away from battery.
4. Wait one (1) minute prior to working on the vehicle
to assure airbag system has been disabled for your
safety.