Brandmotion 9002-7601-V2 - Manual (Page 2)

Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Installation Instructions (Kit # 9002-7601)
7601 Instructions 9-18-12.doc Page 2 of 3
Step 3: Determine location of vehicle power and
ground. Using a vehicle specific service guide and/or
specific wiring diagram and a multi-meter or computer-
safe test light, locate which side of the vehicle contains
Ignition and Ground wires (Chart A).
Chart A
Wire
Color Polarity Function Description Location
Red 12v +
Ignition
controlled
power
This lead will display
12 volt + when the
key is in the RUN
position
Commonly
found on
main
Ignition
harness.
Black (-) Ground Chassis ground
A ground
bolt is
commonly
found in the
front kick
panel area
with other
wires
attached.
Step 4: Splice the red
and black Power Harness
leads into the
corresponding vehicle
wires (Recommended:
Soldering d T-taps as
optional connection
method). Also
recommended is an eyelet
for the ground connection.
Step 5: Insert the connector end of the Camera
Harness through the hole you drilled.
(RECOMMENDED: Protect Camera Harness from sharp
metal edges by applying a small amount of silicone caulk
or a rubber grommet to the area that comes into contact
with the metal).
Step 6: Route Camera Harness. Continue routing
harness to the side of the vehicle that supplies power and
then forward.
Step 7: Connect Camera Harness to supplied
Chassis Harness. The optimal location for this junction
may occur at the top of the liftgate or the inner edge of
the trunk depending on vehicle in which installation is in
(Note: most vehicles may already have existing wires
passing through this area; use this route if at all possible).
Step 8: Route Chassis Harness. It may be necessary
to remove sill plates, pillar covers, seat bottoms, side
panels, etc. In some cases even the seatbelt bolts at the
bottom of the pillars must be removed (CAUTION: Any
bolts removed for safety devices must be retightened to
manufacturer’s specified torque specifications). Use a
plastic trim removal tool to avoid damage to trim pieces.
CAUTION: Once correct wires have been identified,
turn Ignition key OFF and DO NOT TURN key back ON
until the install has been completed (Step 13).