Brandmotion 2000-3801 - Manual (Page 5)

Section 1: Buick LaCrosse Instructions, 2010 – Current
2000-3801 Instructions 10-10-12.doc Page 5 of 24
11. Connect the two white connectors of the DPS harness
to the DPS module. (Figure 7)
Figure 7
12. Connect the DPS turn-on switch to the remaining
connector on the DPS harness. (Figure 8)
Figure 8
13. Reconnect battery of vehicle.
14. Place DPS module with the Bongiovi DPS Acoustics
side face down. Then confirm the DPS unit’s dip
switches are all set to the “down” position –
“DDDDD”. (Figure 9)
Figure 9
15. Turn vehicle ignition key to “ON” position. Turn on
radio head unit for 10 seconds. (Note: There should
be no sound from the speakers). Disconnect white 4-
pin connector from back of DPS module. (Figure 10)
Figure 10
16. Set the DPS dip switches for Buick LaCrosse: The fifth
switch should be flipped to the “up” position –
“DDDDU”. (Figure 11)
Figure 11
17. Plug white 4-pin connector into DPS module and wait
10 seconds. (Note: There should be no sound from
the speakers). Disconnect white 4-pin connector from
back of DPS module.
18. Plug white 4-pin connector back into DPS module.
After a few seconds you should hear sound from the
radio. Ensure radio head unit is working properly
including all speaker channels.
If you do not hear any sounds, recheck connections
and repeat Steps 14 through 18.
19. Disconnect negative battery cable.
20. Remove passenger hush panel by using 7mm socket
driver remove the bolts.
21. Using supplied 24” wire ties, secure DPS module
under front of console or behind carpet on passenger
side upper foot well.
22. Reassemble vehicle and reconnect negative battery
cable.
23. Place Bongiovi DPS Badge on left side of IP center
trim.