Barco R9851560 - Manual (Page 14)

3. Physical Installation of the D320 Lite Digitizer
3.2 Connections
Rear panel inputs/outputs
A B C D
E F G H I
Image 3-1
A LED-WALL OUTPUT
B Power Switch
C Power input
D Not used
E Retractable dust filter
F COM1 : RS232 input
G Not used
H Not used
I
TCP-IP : Ethernet LAN connector
• A : LED-WALL OUTPUT
- LED wall out (Barco proprietary protocol).
• B : Power switch
- The power ON/OFF switch is provide on the rear side of the Digitizer.
o Switch pressed to 1 = the unit starts.
o Switch pressed to 0 = unit totally switched off.
• C : Power input
- Autoranging from 90 to 260 VAC / 130 Watt.
• D : Not used
• F : Retractable dust filter
- The fan intake grill of the Digitizer has a retractable dust filter. This filter can be retracted from the
back of the unit. Check the filter for good functionality on a regular basis. Never allow this filter to
become blocked up and never operate the unit without a good working air filter in place.
• G : COM1 : RS232 input
- Direct master.
- RS232 input port for communication links with local PC.
• H : Not used
• I : Not used
• J : TCP-IP : Ethernet LAN connector
- For future use.
3.3 Removing and inserting a D320 Lite Digitizer input module
There is no need to switch off the D320 Lite Digitizer to remove or insert an input module.
The input modules are hot swappable.
10 R5976471 D320 LITE DIGITIZER 15/11/2006