Brother, Brother & Sons BBS Software ver. 1.0.0.0 - Manual (Page 4)

3.
If a COM Port does not show
up in the “Select COM Port” ,
click the refresh button
and select the appropriate COM Port.
5.
click “Upload Firmware” - the upload to the
Uploader will start.
The following will be displayed:
Status, “Lines Remaining” countdown
and a Progress bar.
The 4 chasing LEDs on the Uploader
will turn off during software upload.
6.
When done uploading, click
OK, when the “File download
completed” dialogue is shown.
The 4 LEDs on the Uploader
will flash once and then resume
the chase.
4.
Click Browse and select the desired Hex file.
The fixture software comes as Hex files.
These can be obtained either from your vendor
or directly from BBS.
Page 3