Bully Dog 47000 Nitrous Kit - Manual (Page 5)

4
NITROUS KIT
8. Install the Master Switch.
‣ Make sure the switch is in the
OFF position.
a. Connect the two silver wires (E
& F) to the silver prongs on the switch.
b. Connect the COLOR battery power wire to the gold
prong on the switch.
9. Connect the Mini-USB cable to
the adapter plug on the GT or
WatchDog.
‣ Do not connect it directly to
the GT or WatchDog.
10. Connect the solenoids
to the wiring harness.
‣ Wire set G
‣ The wires are
color-coded:
◦ Gray: Master Relay
◦ Blue: Relay 1
◦ Brown: Relay 2
◦ Red: Relay 3
◦ Green: Relay 4
‣ Use standard
crimp connectors.
11. Reconnect the battery.
12. Set up the GT or WatchDog (see pages 5-6).
The Master Switch should remain in
the OFF position until the Nitrous Kit
installation is complete.
G
CAUTION! Prevent possible
engine damage by keeping
track of which relay wire
is used to connect each
solenoid.