Bully Dog 32306 Jeep JK 11+ User Manual
Page 2
Advertising
ii
Custom Pod Mount Install
6. Install the appropriate mount adapter and run cables
for your vehicle through the accessory hole in the Bully
Dog A-pillar as needed. (Some route out through, while
some mount back in before install) Pull the driver side
dash panel off to run cables under the dash to the
OBDII Plug.
7. Install Bully Dog A-pillar by
guiding the push pins into the
appropriate hole and pushing
it until it locks in place.
8. Install visor trim piece.
9. Reinstall visor.
10. Finish by inserting plastic
screws.
11. Enjoy the sleek new look of your
Custom Mounted Bully Dog GT!
32306-99
v
1.1
Advertising