Bully Dog 32305 Jeep JK 2007-2010 - Manual (Page 2)

ii
Custom Pod Mount Install
6. Install the appropriate mount adapter and run cables
for your vehicle through the accessory hole in the Bully
Dog A-pillar as needed. (Some route out through, while
some mount back in before install) Pull the driver side
dash panel off to run cables under the dash to the
OBDII Plug.
7. Install Bully Dog A-pillar by
guiding the push pin into the
appropriate hole and pushing
it into place. Secure it with the
remaining screw.
8. Install visor trim piece.
9. Reinstall visor.
10. Finish by inserting plastic
screws.
11. Enjoy the sleek new look of
your Custom Mounted Bully
Dog GT!
32305-99
v
1.1