Bully Dog 51105 Rapid Flow Induction (RFI) Cold Air Intake - Manual (Page 12)

11
Intake Install Prep
Preparing the Intake for Installation:
The steps in this section will prepare the intake for installation, this section includes steps
that are easier to complete with the intake outside of the vehicle.
1. Fit the intake tube into the Rapid Flow box and snap it into place. To secure the tube to
the box push the two items together until the tube snaps into place. The tube should easily
rotate once the interference snaps lock into place.
2. Remove the stock mass air flow
sensor from the stock intake using
the T20 security Torx bit included
with the intake kit and a bit driver.