Bully Dog 84000 Rapid Flow Exhaust System - Manual (Page 10)

9
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 84000
10. Once the entire exhaust system is installed, inspect the system to ensure that no part of the ex-
haust is in direct contact with the chassis or body; adjustments may be necessary. Having any
part of the exhaust system in direct contact with any part of the body or chassis will the cause the
exhaust to rattle.
11. Return to each of the clamps and tighten with a 9/16” wrench or socket driver. The clamps
should be tightened to hand tight, do not tighten to the point that exhaust tubing deforms.
12. The final step is to install the Exhaust Tip, once positioned tighten the bolt on tip using a
17mm hand wrench or socket driver.
9/16”
17mm