Bully Dog 82223 Rapid Flow - Manual (Page 8)

9
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82223
5. Hang the Muffler from Hangers B & C. Ensure that the
louvers are pointing towards the front of the vehicle.
6. Install the “Y” piece into the back of the Muffler. Secure by
tightening Hanger B. The Y Pipe will sit straight up and
down.
7. Install the Passenger Front Piece Tail Pipe by sliding it into
the bottom junction point of the Y-Pipe. Secure with a
Clamp. At this point do not tighten completely to allow for
adjustments.
8. Install the Passenger Tail Pipe Tip and hang from Hanger C.
9. Install the Driver Tail Pipe Tip into the top junction point of
the Y-Pipe. You may need to zip-tie the brake lines away
from the exhaust, otherwise heat may melt them.
10. Install the Driver Tail Pipe Tip and hang from Hanger D.
Install Muffler
Muffler
Muffler
Install Y-Pipe
Hanger C
Y-Pipe
Muffler
Install Passenger Front Piece Tail Pipe
Driver Front Piece Tail Pipe
Passenger Front Piece Tail Pipe
Hanger C
Passenger Tail Pipe Tip Brake Lines
SwITCH DIRECTIONS: THE NEXT STEPS wILL BE FROM THE BACk OF THE TRUCk