Bully Dog 82200 Rapid Flow - Manual (Page 9)

8
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 82010,82200
8. At this point, it is time to install the second Straight Pipe. Cut the Straight Pipe to the desired length, keeping in
mind that you need 3 inches of overlap when you cut the pipe. Do not cut the flared end.
9. Once the entire exhaust system is installed, inspect the system to ensure that no part of the exhaust is in direct
contact with the chassis or body; adjustments may be necessary. Having any part of the exhaust system in direct
contact with any part of the body or chassis will cause the exhaust to rattle.
10. Return to each of the Clamps and tighten with a 13mm wrench or socket. Again do not over tighten the
Clamps.
3”
13mm
Measure for Second Straight Pipe
Complete System Installed