Rapid flow installation – Bully Dog 81412 Rapid Flow User Manual
Page 5
Advertising
6
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81412
4
1. Use a sawzall to cut the exhaust
immediately behind the muffler.
2. Then cut the exhaust 4 inches
behind the catalytic converter in
front of the band clamp.
3 Remove each piece of the stock
exhaust system, including the stock hangers. To
make removal the hangers easier, it is recom-
mended that you use a silicone spray on each of
the rubber hangers that hold the stock exhaust.
ImPoRTaNT: It is illegal in all 50 states and Canada to remove the catalytic converter.
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust system.
#2 Cut Exhaust
in front of band clamp
#1 Cut Exhaust after muffler
#4 Remove necessary exhaust hangers
Advertising