Bully Dog 81223 Rapid Flow - Manual (Page 9)

10
10
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81223
14. At this point it is time to install the Straight Pipe,
depending on the vehicle you may not need it. You
will need to measure the Straight Pipe to the correct
length, keeping in mind that you will need to have an
extra 3 inches of overlap when you cut the pipe. Do
not cut the flared end.
15. Once the entire exhaust system is installed, inspect
the system to ensure that no part of the exhaust is in di-
rect contact with the chassis or body; adjustments may
be necessary. Having any part of the exhaust system in
direct contact with any part of the body or chassis will
the cause the exhaust to rattle.
16. Return to each of the Clamps and tighten with a
9/16” wrench. Again, do not over tighten Clamps.
Measure from Straight Pipe
Adapter Pipe
Muffler
3”
Important: Do not over-tighten clamps. too much
torque will result in deformation of the exhaust. For best
results when doing the installation, tighten the clamps
enough to hold the exhaust pieces in place, but don’t
tighten down until the entire exhaust system is installed.
9/16”
Complete System Installed
Straight Pipe