Bully Dog 81201 Rapid Flow - Manual (Page 5)

4
4
rAPid FlOW inSTAllATiOn
rapid Flow exhaust # 81010,81201
REMOVAL OF STOCk EXHAUST SySTEM
In these steps you will remove the stock exhaust
system.
1. Use a sawzall to cut the exhaust immediately be-
hind the muffler.
2. Cut the exhaust on one of the Straight Pipes in
front of the muffler.
3. Use a Sawzall to cut the exhaust system at the
bottom of the Down Pipe.
4. To make removing the Hangers an easier process,
it is recommended that you use a silicone spray lu-
bricant to spray each of the rubber hangers holding
the stock exhaust.
5. Remove each piece of the stock ex-
haust system, including the stock ex-
haust hangers. To remove the Down
Pipe use a 7/16” deep socket to loosen
the stock band clamp. The stock band
clamp will be used on the new system.
Band Clamp
7/16”
Hang the Hangers
Cut Exhaust in Front of Muffler
Cut Exhaust at Bottom of Downpipe
Remove Hangars Loose Band Clamps