Calculated Industries 3302 - Manual (Page 6)

 ³ '
,0(16,21
0
$67(5
3
/86 Š
Feet/Inch or Metric Switch
For your convenience, a switch on the left side of
the unit allows you to set the measurement mode to
either the English/Imperial Feet-Inch (F/I) system
or to the Metric (Met) system.
Aim Assist ™ Pointer Lamp
The Aim Assist
™
pointer lamp is designed for
many years of service under normal operation.
Should the bulb burn out, please contact the manu-
facturer for replacement details.
Display Accuracy
The Dimension Master Plus has an eleven-digit
display. This is made up of seven digits for the
normal display and four digits for the fractional
display. In a standard calculation, the calculation is
carried out to a 10-digit internal accuracy, and then
rounded to a 7-digit standard display using a 5/4
rounding.
Automatic Shutoff
The Dimension Master Plus is designed to shut it-
self off after approximately 7 minutes of non-use.
Any value shown on the display is cleared at this
point. All values stored in the memory registers re-
main unchanged.
None/Error Messages
If the Dimension Master Plus is unable to measure
a distance, two beeps sound and either the word