Calibrated Software AVC-Intra Create v2 - Manual (Page 35)

Page | 36
Manually configuring for 10-bit YUV422 Export in PPro
1. In the ‘Export Settings’, please choose ‘QuickTime’ for the format
2. Click on the ‘Video’ Tab in the ‘Export Settings’
a. Choose the Calibrated AVC-Intra Create Compression Type that best matches your Sequence Settings in the
‘Video Codec’ drop down menu. (Please see the ‘Overview’ section at the beginning of this chapter to see
what Compression Type matches best with your Sequence Settings)
b. Do NOT press the ‘Codec Settings’ button as this will cause Premiere Pro to give an error message before
encoding
– since the default encoding colorspace of Calibrated AVC-Intra Create for OSX is ’10-bit
YUV422/Gamma’ then there isn’t a need to setup any of the codec settings in Calibrated AVC-Intra Create for
OSX for Premiere Pro.
c. Make sure the ‘Quality’ slider is 100
d. Make sure the Width/Height are at either 1920x1080 or 1280x720 and PAR is at Square Pixels (1.0) for AVC-
Intra 100 Encoding, OR 1440x1080 or 960x720 and PAR is at HD Anamorphic (1.333) for AVC-Intra 50
encoding - pick the Resolution/PAR that matches the AVC-Intra Compression Type you are encoding to.
e. Make sure the Field Type matches the Calibrated AVC-Intra Compression Type you are exporting to -choose
‘Upper First’ for interlaced compression types or ‘Progressive’ for progressive compression types.
f.
Make sure the ‘Frame Rate’ matches the Calibrated AVC-Intra Compression Type you are exporting to –
please see the ‘Overview’ section at the beginning of this chapter to see the proper frame rates for the
different AVC-Intra Compression Types.
g.
Make sure that ‘Render at Maximum Depth’ is CHECKED
h. Make sure that the Bit Depth
is set to ’24 bit’ (bit depth needs to be 24 are you will get a render error)
i.
Make sure that ‘Use Maximum Render Quality’ is CHECKED
j.
Make sure that ‘Use Previews’ is NOT CHECKED
3. And you’re ready to export