Clay Paky ASTROSCAN (HMI 1200) - Manual (Page 2)

8
• Packing contents
Besides the projector and the
rotating mirror head, the packing
also contains the following
accessories:
- This instructions manual
code 099596 (1).
- 2 spacers code 167002/001 (2).
- 1 right bracket support plate
code 167003/001 (3).
- 1 left bracket support plate
code 167003/002 (4).
- 2 eyebolts M8x20mm
code 167004/001 (5).
- 2 nuts M8 code 020106/006 (6).
- 2 knobs code 020502 (7).
- 2 plane washers ø10,5mm
code 020210/004 (8).
- 1 bracket code 101011/001 (9).
- 4 bracket bushings
code 101014/001 (10).
- 4 countersunk washers
code 080606/001 (11).
- 4 countersunk head screws
M8x20mm code 020005/001 (12).
- 1 Allen wrench 5 mm
code 050001 (13).
- 4 handles
code 082017/001 (14).
- 8 screws TCEI M8x20
code 020002/029 (15).
- Multilingual label (16) with safety information
code 081968 (located in the projector lampholder compartment).
- 1 safety ropes code 105041/001 (17).
2
13
14
15
12
1
4
3
5
6
7
8
9
10
11
17
16
UNPACKING AND PREPARING 2
• Unpacking
Open the wooden box from the top, take all the accessories out of the box and
remove the polystyrene containing structures.
Open the plastic bag, remove the projector from the box frame and position it on a
horizontal top where access is easy to carry out the following preliminary work.
• Preparing the warning label
Find the warning label (19) on the re-lamping cover (18) and, if necessary, replace it
with one of the optional multilingual labels (16) located in the projector lamp
compartment. For the instructions on opening the projector, read paragraph
4 MAINTENANCE.
CAUTION: Read carefully and meticulously apply the information and
instructions given on this label. In addition, check it is never removed as it
contains important safety information.
• Fitting the bracket
• Fitting the handles
6 2 4 5
8 7
3
12
12 11
9
10
13
15
18
14 4
19
22
25
20 23
24 21
• Fitting the lamp
Refer to the instructions for opening the projector and changing the lamp in
paragraph 4 MAINTENANCE.
• Fitting the rotating mirror
head
Fit the rotating mirror head (20)
to the projector and secure it
with the three knobs (21).
Connect the mirror plug (22) to
the socket (23) located on the
side of the projector.
Connect the metal safety
wire (24) to the tag (25)
on the projector.