Clay Paky SHARPY (C61375 ) - Manual (Page 31)

31 SHARPY
405
(15.94")
330
(12.99")
345
(13.58")
185
(7.28")
475
(18.70")
280
(11.02")
450
(17.72")
315
(12.40")
Power supplies available
115/230V 50/60Hz
Input power:
350VA a 230V 50Hz.
Total output
Max 8000 lumens
Lamp:
Lamp system with a short arc burner in a reflector
Philips MSD Platinum 5R (L10103)
- Output Lamp power: 189W
- Colour temperature 8000 K
- Luminous flux 7950lm
- Average life 2000 h
- Any working position
Osram Sirius HRI 190+ (LAM002)
- Output Lamp power: 190W
- Colour temperature 8200 K
- Luminous flux 8100lm
- Average life 3000h
- Any working position
Motors:
13 stepper motors, operating with microsteps,
totally microprocessor controlled.
Channels:
Max 20 control channels.
Inputs:
DMX 512
Ethernet
Movable body:
• Movement by means of two stepper motors,
controlled by microprocessor.
• Automatic repositioning of PAN and TILT after
accidental movement not controlled by control
unit.
• Travel:
- PAN = 540°
- TILT = 252°
• Maximum speeds:
- PAN = 2.45 sec
- TILT = 1.30 sec
• Resolution:
- PAN = 2.11°
- PAN FINE = 0.008°
- TILT = 0.98°
- TILT FINE = 0.004°
• Accuracy:
- Resolution ± 0,15° (Range 0,3°)
IP20 protection rating:
• Protected against the entry of solid bodies larger
than 12mm (0.47”).
• No protection against the entry of liquids.
CE Marking:
Complies with the following European Directives
- 2006/95/EC (LVD)
- 2004/108/EC (EMC)
- 2011/65/EU (RoHS).
Safety Devices:
• Bipolar circuit breaker with thermal protection.
• Automatic break in power supply in case of
overheating or failed operation of cooling system.
Cooling:
Forced ventilation with axial fans.
Body:
• Aluminium structure with die-cast plastic cover.
• Two side handles for transportation.
• Device locking PAN and TILT mechanisms for
transportation and maintenance.
Working position
Functioning in any position.
Weights:
about 19 Kg (41lbs 13ozs).
TECHNICAL INFORMATION
CAUSE AND SOLUTION OF PROBLEMS
THE PROJECTOR WILL NOT SWITCH ON
PROBLEMS
ELECTRONICS NON-OPERATIONAL
DEFECTIVE PROJECTION
REDUCED LUMINOSITY
POSSIBLE CAUSES CHECKS AND REMEDIES
No mains supply.
Lamp exhausted or defective.
Signal transmission cable faulty or disconnected.
Incorrect addressing.
Fault in the electronic circuits.
Lenses or reflector broken
Dust or grease deposited.
Check the power supply voltage.
Replace the lamp. (See instructions).
Replace the cables.
Check addresses (see instructions).
Call an authorised technician.
Call an authorised technician.
Clean (see instructions).