ClearCube R Series Pentium 4 - Manual (Page 94)

84 • User Port Installation ClearCube Product Manual and Installation Guide
I/Port Installation
Caution Statements
Improper connection, mounting, or use of this product could result in component
failure or undesired interference. Read the following caution statements before setting
up and operating your I/Port.
Setup
• Do not connect to AC power until all other connections are made, including the
power adapter. Connecting or disconnecting components or equipment on the
back panel when the I/Port is receiving AC power can cause power surges and
damage the device.
• Do not force a connector into its socket. If any undue resistance is encountered,
ensure that the connector is correctly oriented to the receptacle.
• Do not attach the I/Port to a telephone jack or other powered network connection.
This will permanently damage the I/Port. This damage is not covered under the
ClearCube Technology limited warranty.
Orientation and Venting
• Allow sufficient space around the I/Port for ventilation. Do not place the device in
any enclosure that restricts airflow around the device. Do not place any objects on
the device. Product environmental specifications are listed in Appendix A.
• Mount the Eon e100 I/Port only vertically.
• Mount the Capio One vertically or in accordance with the instructions provided.
Improper orientation could inhibit the dissipation of heat from the device and
damage it.
Power Sources
• To ensure regulatory compliance, use only the power supply included in the
shipping carton with the I/Port, or a ClearCube-approved equivalent. Also, the
noise suppressor (ferrite bead) included in the box with the I/Port must be
installed on the network cable as described.
• To prevent accidental loss of power, brown out, and spikes that could damage the
I/Port, avoid connecting the I/Port to any AC outlet that can be accidentally
switched off, including power strips, or hard resetting the I/Port by holding down its
power button.
• When turning off the I/Port, be sure to perform a complete shutdown via the user
interface or power button. Do not disconnect the AC power cord or shut off power
at a circuit breaker, etc., to turn off the device.
• Surge protectors for electrical devices are recommended in areas of frequent
lightning. However, when lightning is occurring, your equipment should be
properly shut down and unplugged from AC power until the storm has passed.
• Be careful to not interrupt power while the I/Port is receiving a software update.