CommScope E-ATM300(EFCT) - Manual (Page 6)

E-ATM300 Field Confi guration Tool (EFCT)
ii August 2008 Bulletin 639556 • Revision B iv December 2008 Bulletin 639556 • Revision C
SAFETY NOTICE
The installation, maintenance, or removal of an antenna
requires qualified, experienced personnel. Andrew
installation instructions are written for such installation
personnel. Antenna systems should be inspected once
a year by qualifi ed personnel to verify proper installation,
maintenance, and condition of equipment.
Andrew disclaims any liability or responsibility for the results
of improper or unsafe installation practices.
Installation Training Available at Andrew Institute
Do not install near power lines.
Power lines, telephone lines,
and guy wires look the same.
Assume any wire or line can
electrocute you. Do not install on a wet or
windy day or when
lightning or thunder is
in the area. Do not use
metal ladder. Wear shoes with rubber soles
and heels. Wear protective
clothing including a
long-sleeved shirt and rubber
gloves.
IMPORTANT
Before installing the EFCT Tool to operate the
ATC200-LITE-USB controller, please DOWNLOAD
the latest antenna defi nition fi le and controller
software from the Commscope web site at
www.commscope.com. Please register online to
receive E-mail notifi cations for software updates.
WARRANTY NOTICE
Proper installation procedures must be followed when
installing and operating RET equipment. Failure to assure
installations are done properly by trained installation
personnel and to follow procedures discussed in this bulletin
may cause warranty for such products to be void.
Andrew requires that all RET installations be pre-tested
and confi gured prior to installation. Failure to conduct pre-
test and pre-installation procedures defi ned by Andrew will
void warranty.
Notices and Precautions