Constellation Audio Centaur and Centaur Mono - Manual (Page 5)

5
Location
The Centaur Mono and Centaur must be installed in an area with adequate ventilation. There should be at
least 6 in/15 cm of clearance between the vents on the side of the amplifier(s) and the nearest wall or
cabinet. Ensure that no curtains or shades can be lowered in a way that will block the amplifier’s vents. If the
amplifier is installed in a cabinet or in an equipment closet, ensure that the cabinet/closet has adequate
ventilation. Installation in an unventilated cabinet or closet may cause the amplifier to overheat.
The amplifier requires a room-temperature environment to operation properly. Ambient temperature should
be about 70°F/21°C, plus or minus 10°F/5°C. Never install the amplifier in a place where it may be
exposed to direct sunlight, and do not install it next to a room heater, radiator, air conditioner, etc. Ambient
temperature can rise even more quickly with two Centaur Monos, so if you place both of them in an enclosed
or tight space, make extra sure to provide plenty of ventilation and air flow.
Make sure that the amplifier will not be exposed to moisture. Do not locate it in an area where it might be
spilled on, and do not place it in a humid location (such as an unfinished basement).
Installing the Centaur Mono or Centaur in a place where it will be exposed to direct sunlight or moisture, or
where it will not have adequate ventilation, will void your warranty.
Speakers
The Centaur Mono and Centaur sufficient voltage and current to drive practically any loudspeaker made,
regardless of the speaker’s impedance, sensitivity, or “power rating.” However, the Centaur and, especially,
the Centaur Mono have enough power to damage some loudspeakers if used carelessly. When you turn up
the volume on your preamp, do it gradually. If you hear distortion, crackling noises, or mechanical thumps
from the speaker, turn the volume down immediately.
You can best appreciate the amplifier’s performance by connecting it to a large set of full-range
loudspeakers. It will sound excellent with small speakers, too, but if you connect it to a small set of speakers,
avoid turning the volume on your preamp to maximum.
Constellation Audio is not responsible for damage of any speaker connected to the Centaur Mono or Centaur.
In the event of malfunction
Do not under any circumstances open the cabinet of the amplifier. There are no user-serviceable parts inside.
Opening the cabinet can present a shock hazard even if the AC power is disconnected. Any alteration or
modification of the amplifier’s internal parts or circuit will immediately void your warranty.
If your amplifier does not function correctly, refer to the Troubleshooting section at the end of this manual. If
you are still unable to resolve the problem, contact your Constellation Audio dealer.
If any liquid is spilled on the amp, or if any metal object (such as a staple or a paper clip) is inadvertently
forced in through the vents, immediately disconnect the AC power and contact your Constellation Audio
dealer.