Constellation Audio Virgo II Preamplifier - Manual (Page 11)

11
15. Standby/power
Push this button to turn the Virgo II on and off. When you turn the unit on, it will take a few seconds for the
power supply and preamp to warm up. When the Virgo II is ready for use, its LCD screen will show the most
recently selected input. To put the unit in Standby mode—which will silence the audio but keep the power
supply on so the unit stays warmed up—press this button again after turning on the power.
Hold this button down for 5 seconds to turn the Virgo II off. The unit will enter cool-down mode for 10 seconds.
During cool-down, no buttons on the unit or remote will operate.
16. Multifunction button
The multifunction button serves different functions depending on which control screen is shown. A label on the
LCD display will show the function of the button.
17. Mute
Press this button to silence the audio temporarily. Because the Virgo II uses a relay to perform the Mute
function, it may take a second or so for this control to respond. The volume numbers on the LCD will flash
when the preamp is in Mute mode. Press the button again to restore the sound.