Decimator Design DMON-12S User Manual
Page 15
DMON‐12S Hardware Manual for Firmware Version 1.1
Copyright © 2014 Decimator Design Pty Ltd, Sydney, Australia
15
4. SETUP / AUTO SAVE (Parameter)
This parameter will determine if any changes will be saved to memory when changes are made.
When the sub menu is highlighted, press ENTER to toggle through the following selections:
1.) Yes
2.) No
5. SETUP / Demo Cycle (Parameter)
The Demo cycle setting is used for cycling through multiple layouts, windows or inputs on a time delay. When
the sub menu is highlighted, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to move left or right through the following cycle types:
1.) None
2.) Output Select
3.) MV Windows
4.) MV Layouts
Note: The parameter will only be updated when leaving this sub‐menu.
6. SETUP / Demo Cycle Time (Parameter)
The Demo Cycle Time determines the amount of time to elapse before cycling to the next item. When the sub
menu is highlighted, press the ENTER button to enter this sub‐menu.
Press the < and > buttons to move left or right through the time until the unit moves to the next item in the
cycle.
Default time is 10 Seconds, Maximum time is 256 Seconds
Note: The parameter will only be updated when leaving this sub‐menu.