DJI F330 v1.5 - Manual (Page 6)

©2012 DJI Innovations. All Rights Reserved.
6
Assembly
Top Board
S M2 5x6
crew
.
Bottom Board
S M3x8
crew
1 2
3
4
Step 1
Install bottom board
Step 2
Install autopilot system
Step 3
Install motors, ESCs
Step 4
Install top board
Step 5
Install propellers
Install screws by appropriate force to
prevent breaking threads. Use adequate
screw glue for installing screws.
Please wire neatly. Make sure wires will not
be cut by frame boards and propellers.
Smooth out the boards edge if necessary.
Please install propellers after autopilot system configuration
procedure. Make sure the rotation direction of propellers are
the same as the figure shows.
When mounting the propellers, do not use any thread locker,
just tighten the nuts to the end manually then use the wrench
to tighten it about 50°.
In up figure, arms ①② front of craft, arms ③④ are back of craft. You'd better choose the same color arms for the same direction. See from top, motors
on arms ①③ rotate counter-clock wise, use propellers 8045; motors on arms ②④ rotate clock wise, use propellers 8045R.