DJI S800 - Manual (Page 2)

©2012 DJI Innovations. All Rights Reserved.
2
Assembly & Connection
The part with the control board attached is defined as left, the other part is right. Make sure to make a distinction
between the left and the right servos.
STEP1 Servo Installation
(If the servos have already been installed, please skip this step.)
1. Define and mark two servos as left servo and right servo.
2. Connect the left servo to the [L] port on the control board, and the right servo to the [R] port.
3. Keep pressing the SET button with the aid of a small tool, and then power on. You will see the yellow LED
flashes quickly, and then wait until the servos have finished their position initialization.
4. Make sure the arm connecting to the servo is parallel to the link rod. (Shown in the following Fig).
5. Power off, and assemble the left and right servos to the left and the right parts of the landing gear.
STEP2 Mechanical Assembly
1. Assemble the left and the right parts respectively, and then fix the screws at the joints with appropriate
screw thread lock.
2. Connect the left and right parts with the connecting rod.
3. For safety reasons, make sure to connect the springs to both parts.
4. Assemble the battery Bracket, referring to the “S800 User Manual”.
STEP3 Electrical Connections
1. Plug the cables from the servos into the correct ports on the control board. Make sure the right servo is
connected to the [R] port, and the left servo to the [L] port.
2. Connect the required 2-position switch channel of the R/C receiver to the [IN] port.