Metrohm MiPT - Manual (Page 14)

3.2 Installing the Dosino
￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
8 ￭￭￭￭￭￭￭￭
IC-Ausrüstung: MiPT
1 Hanging the Dosino holder onto the ion chromatograph
￭ Loosen the bottle holder on the ion chromatograph.
￭ Clamp the Dosino holder under it.
￭ Fasten the bottle holder again.
2 Attaching the Dosino to the holder
￭ Place the Dosino onto the Dosino holder.
￭ Fasten the Dosino to the Dosino holder by tightening the thread
adapter from below.
3 Connecting the Dosino to the ion chromatograph
NOTE
The ion chromatograph must be switched off when the Dosino is
being plugged to the MSB connector.
￭ Check whether the ion chromatograph is switched on.
If this is the case, switch off the ion chromatograph.
￭ Plug the Dosino cable into one of the ion chromatograph's MSB
connectors.
Alternatively, the Dosino can also be mounted to the Sample Processor
(see the manual for the Dosino).