Metrohm 891 Professional Analog Out - Manual (Page 17)

￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭￭
7 Operation
891 Professional Analog Out
￭￭￭￭￭￭￭￭ 11
7 Operation
The 891 Professional Analog Out is configured and the data sources
are assigned to the output channels in the MagIC Net software. Addi-
tional information on operating the software can be found in the docu-
ment "MagIC Net Tutorial" or in the online help.
Configuration
If the 891 Professional Analog Out is connected to an ion chromatograph
or an Extension Module, it is recognized automatically when MagIC Net is
started but it will not be entered into the device table as a stand-alone
device.
Displaying configuration data
1 In the Configuration program part, open the properties of the IC
instrument to which the 891 Professional Analog Out is connected.
2 Open the Analog Out tab.
The name and the serial number of the 891 Professional Analog Out
are shown. These data cannot be modified.
The actual assignment of the data sources to the output channels takes
place in the Method program part, on the four tabs for the analog out-
puts: Out1 / Out2 / Aux1 / Aux2. For this, the instrument to which the
891 Professional Analog Out is connected has to be selected in the device
window. The four analog outputs can be found on the four tabs on the
back.
Configuring output channels
1 Open the Method program part.
2 In the Devices subwindow, select the instrument to which the 891
Professional Analog Out is connected.
The data for the four analog outputs Out 1 / Out 2 / Aux 1 / Aux 2 is
to be found on the four tabs at the back.
3 The following indications can be made for each channel: