Boca Research Adjustable MC Ghost - Manual (Page 16)

The position of the tear can be controlled by changing the cut count setting in the
OPERATOR MENU (see Appendix A). If you are not able get the desired tear
position, then make sure your ticket stock was manufactured to proper specifications.
Once a month the opto eye should be blown off with air to remove any accumulated
paper dust. A soft haired brush can also be used if air is not available.
Figure 8a - Auto configuration opto and Load opto
10
Auto configuration opto
Load opto
Figure 8b - Print position and Tear opto
Print position and
tear position opto