Banner Safety Cables - Manual

Datasheet
The BWA-UCT-900 is shown.
• Connects a SureCross Gateway or MultiHop Radio to a Windows PC
USB port
• Cable BWA-HW-006 supplies power for one DX80 Gateway or one
MultiHop Radio operating at 250 mW
• Cable BWA-UCT-900 supplies power for one DX80 Gateway or one
MultiHop Radio operating at 1 Watt
• Supports baud rates of 9600, 19200, and 38400
• Converts USB to RS-485 (2-wire) with a Euro-style connector
• Supports Windows XP and Vista
• Download the User Configuration Tool or MultiHop Configuration Tool
software free from Banner Engineering's Wireless I/O Products website
Do not use BWA-HW-006 to connect a Performance Gateway or MultiHop Radio operating in 1 Watt mode. Always
configure the Performance and MultiHop models to operate in 250 mW mode before connecting them to your computer to
avoid damaging your USB port.
To supply power to 1 Watt radios during configuration, use cable BWA-UCT-900.
When plugging this cable into your computer for the first time, give the cable 1 to 2 minutes to check your computer for
the proper driver, download the driver, then install it. Plug the cable into your Gateway; the cable should supply enough
power to the Gateway to configure it.
For additional information, updated documentation, and accessories, refer to Banner Engineering's website,
www.bannerengineering.com/surecross .
Models Adapter Length
BWA-HW-006 RS-485 to USB
1 meter
BWA-UCT-900 RS-485 to USB, with wall plug to power 1 Watt radios during configuration
To be used with the DX80...C models, these adapter cables requires cable model MQDMC-401.
4-pin Euro-Style Connection (Female)
No. Wire Color DX80 Wiring DX80...C Wiring
1
2
3
4
1 Brown 10 to 30 V dc V+
2 White RS485 / D1 / B / + Tx
3 Blue dc common (GND) V-
4 Black RS485 / D0 / A / – Rx
Connecting dc power to the communication pins will cause permanent damage.
SureCross RS-485 to USB Adapter Cable
P/N 140377 Rev. C 8 January 2014
0 140377 0