Britax Boulevard - Manual (Page 25)

23
IMPORTANT:
Britax recommends that tether be used at all times. Using tether will
improve the stability of child restraint and reduce risk of injury.
If vehicle does not currently have a tether anchor attachment, refer
to your vehicle’s owner’s manual or contact vehicle manufacturer for
assistance.
The back angle of child restraint should not exceed 45º from vertical
when properly installed in rear-facing position.
NOTE: It may be necessary to loosen tether and/or vehicle seat belt
before adjusting recline position. Tether and/or vehicle seat belt must be
properly re-tightened per the instructions in this manual.
Removal
Disconnect Versa-Tether, if necessary. While pushing restraint firmly into
vehicle seat, release lock-off and vehicle belt.
•
•
•
Installation: Versa-Tether ®
Safety Information
WARNING!
The position of vehicle belt buckle can
affect stability of the child restraint. In a crash, an improperly
positioned buckle could become loose and the child would be
unprotected.
When using restraint in forward-facing mode, attach Versa-
Tether® only to tether anchors identified by vehicle manufacturer
as tether-anchorage points. Use of other locations is not approved
or permitted.
If a tether anchorage is not available, DO NOT modify vehicle
without advice from vehicle manufacturer.
DO NOT hook Versa-Tether to bottom of a vehicle seat adjuster!