Banner MSM Series Corner Mirrors - Manual

MSM Series Dimensions
MSM Corner Mirrors
For use with Banner Safety Light Screen Systems
Printed in USA P/N 43685E0A
MSM Series Description
Banner MSM Series corner mirrors are designed for use with MICRO-SCREEN ® and
MINI-SCREEN ® System sensors, but may also be used with other light screen
systems. They enable guarding along more than one side of an area using only one
emitter/receiver pair.
MSM Series mirrors are small and lightweight. Brackets are included for quick and
easy mounting. Once mounted, a unique mirror end cap design allows rotation of the
mirror to any angle.
The rear-surface glass mirrors are rated at
85 percent efficiency. See pages 3 and 4 for
specific information on sensing range and
excess gain.
MSM Series mirrors are available in 12
lengths which correspond to MINI-SCREEN
sensor lengths. Mirror length is two inches
greater than the corresponding sensor’s
defined area.
MSM Series Features
• Designed for use with Banner
MICRO-SCREEN, MINI-SCREEN and
MACHINE-GUARD Safety Light
Screen systems
• Allows guarding of multi-sided
applications with one emitter and
receiver pair
• Small and lightweight
• Mounting bracket design allows 360°
rotation of mirror for easy installation
and alignment
• Available in 12 lengths
Mirror
Model Part
Number
Reflective Area
Length (Y)
Mounting
Length (L1)
Mirror Height
Overall (L2)
MSM4A 43162 165 mm (6.5") 221 mm (8.7") 191 mm (7.5")
MSM8A 43163 267 mm (10.5") 323 mm (12.7") 292 mm (11.5")
MSM12A 43164 356 mm (14") 411 mm (16.2") 381 mm (15")
MSM16A 43165 457 mm (18") 513 mm (20.2") 483 mm(19")
MSM20A 43166 559 mm (22") 615 mm (24.2")
MSM24A 43167 660 mm (26") 716 mm (28.2") 686 mm (27")
MSM28A 43168 762 mm (30") 818 mm (32.2") 787 mm (31")
MSM32A 43169 864 mm (34") 919 mm (36.2") 889 mm (35")
MSM36A 43170 965 mm (38") 1021 mm (40.2") 991 mm (39")
MSM40A 43171 1067 mm (42") 1123 mm (44.2") 1092 mm (43")
MSM44A 43172 1168 mm (46") 1224 mm (48.2") 1194 mm (47")
MSM48A 43173 1270 mm (50") 1326 mm (52.2") 1295 mm (51")
Note: The mounting brackets may be
inverted from the positions shown
at right (flanges pointing “inward”
instead of “outward,” as shown).
When this is done, dimension L1
decreases by 56.9 mm (2.24"), and
rotation decreases to ± 45°.
584 mm (23")