Banner PVD100 Pallet Sensor - Manual (Page 8)

Brackets
All measurements are listed in millimeters.
Bracket Selection Table
Bracket Model Requires Use of
Bracket Model(s) May Be Used with
Bracket Model(s)
SMBPVD1
(included with
PVD System)
N.A.
SMBPVD100A(B)
SMBPVD225A(B)
SMBPVA2
SMBPVD100A(B)
SMBPVD225A(B)
N.A.
SMBPVD1
SMBPVA5(10)
SMBPVA9
SMBPVA2
SMBPVA5C
SMBPVA10C
N.A.
SMBPVD100A(B)
SMBPVD225A(B)
SMBPVA7
SMBPVA8
Bracket Model Requires Use of
Bracket Model(s) May Be Used with
Bracket Model(s)
SMBPVA9
N.A.
SMBPVD100A(B)
SMBPVD225A(B)
SMBPVA2
N.A.
SMBPVD100A(B)
SMBPVD225A(B)
SMBPVA7 SMBPVA5C
or
SMBPVA10C SMBPVD100A(B)
SMBPVD225A(B)
SMBPVA8 SMBPVA5C
or
SMBPVA10C SMBPVD100A(B)
SMBPVD225A(B)
NOTE: Standard mounting brackets are included with each PVD System. The following brackets are in addi-
tion to the standard brackets.
SMBPVD..A & SMBPVD..AB
• Heavy-duty protection brackets
• Some models include DIP-
switch access port
• Cold-rolled steel with zinc finish
• May be used with SMBPVA..C
for mounting to SMBPVA7 or
SMBPVA8 brackets
L
35.7 mm
(1.40 in.)
21.2 mm
(0.83 in.)
21.2 mm
(0.83 in.)
L
35.7 mm
(1.40 in.)
Models with DIP
Switch Access
Port Models with No DIP
Switch Access L
SMBPVD100A SMBPVD100AB 140 mm (5.5
in)
SMBPVD225A SMBPVD225AB 269 mm
(10.6 in)
SMBPV..C
• Back-mounted bracket for
mounting to SMBPVA7 or
SMBPVA8 brackets
• Cold-rolled steel with zinc
finish 16
6 x Ø4.8
4 x Ø5.2
2 x Ø7.3
41
L
Model L
SMBPVA5C 170.0 mm
SMBPVA10C 298.5 mm
PVD Series Parts Verification Sensor
8 www.bannerengineering.com - tel: 763-544-3164 P/N 113230_web
Rev. E