Hinkley Lighting 25W G9 STEP LIGHT 58025 User Manual

Start here, Installation instructions, Lamp installation replacement

Advertising
background image

H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com

installation instructions

Family: 120V Series Step Light Item No. 58025/58009 BZ

1. Find a clear area in which you can work.
2. Carefully review instructions prior to assembly.
3. Gather tools required : WIRE STRIPPERS, PHILIPS HEAD SCREWDRIVER,
SILICONE GREASE, THREAD SEALANT.
• Save these instructions for future reference.

start here

58025 58009

WARNING: LUMINAIRE MUST BE INSTALLED AND GROUNDED IN ACCORDANCE
WITH THE NATIONAL ELECTRICAL CODE (NEC) AND LOCAL CODES. FAILURE TO
DO SO MAY RESULT IN SERIOUS INJURY AND/ OR DAMAGE TO THE LUMINAIRE.
FOR ANY SPECIAL APPLICATIONS NOT COVERED, PLEASE CONTACT HINKLEY
LIGHTING FOR ASSISTANCE

FIXTURES WHICH MAY COME IN CONTACT WITH OR BE EXPOSED TO MOISTURE
(I.E. OUTDOORS) SHALL BE INSTALLED ON A GFI (GROUND FAULT INTERRUPTOR)
POTECTED CIRCUIT.

ALWAYS USE UL RECOGNIZED WIRE CONNECTORS FOR CONNECTIONS.

1. Please refer to the mounting instructions located on the back of this sheet to
continue installation of this fixture.

lamp installation replacement

1. To prevent electrical shock, disconnect from the electrical supply before servicing.
2. Remove face plate (A) from housing (B) by loosening 2 philips screws on front of
louver (C) - see Drawing 1.
3. Replace lamp with correct wattage and type marked on fixture label.
CAUTION: DO NOT EXCEED MAXIMUM WATTAGE MARKED ON LUMINAIRE LABEL.

Info 58025 BZ: Lamp Type G9, Maximum Wattage is 25 watts per bulb.
Info 58009 BZ: Lamp Type G23-2, Maximum Wattage is 9 watts CFL per bulb.

Drawing 1 - Lamp Installation

A

B

C

WARNING: TO REDUCE THE
RISK OF FIRE, OR INJURY
TO PERSONS:
1.
Turn off/unplug and allow
to cool before replacing lamp.
2. Lamps get hot quickly!
Contact only switch/plug
when turning on.
3. Do not touch hot lens,
guard or enclosure.
4. Keep lamp away from
material that may burn.
5. Do not operate luminaire
fitting with a missing
or damaged cover.

HINKLEY LIGHTING

Advertising
Table of contents