Hinkley Lighting VALLEY 4705VK - Manual

assembly instructions
Family: Valley Item No. 4705 VK/BN
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the fixture glass.
start here
47
05
1. To install glass, remove socket ring (4) and spacer (2) from socket (B) - see Drawing 2.
2. Slip glass (3) over socket (B).
3. Slip spacer (2) and then thread socket ring (4) onto socket (B) to secure glass (3).
4. Use socket ring tool to tighten socket ring (4). Notches in socket ring fit into notches
on socket ring tool. Tighten socket ring until snug. Do not overtighten.
5. Repeat step 1-3 for remaining glass.
6. Fixture can now be lamped accordingly.
Drawing 1 - Assembly
Drawing 2 - Glass Installation
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. To assemble main body, spread arms (A) located on the main body assembly (1),
until they are equally spaced 72 degrees apart - see Drawing 1.
2. Please refer to the hanging instruction sheet (I.S. 19) provided to hang fixture. Then
refer back to this sheet to install glass.
4.9.10
72 degrees
apart
1
2
4
3
B
A
notches
socket ring tool
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com