Hinkley Lighting 9W CFL BRICK LIGHT 59009 - Manual (Page 2)

mounting instructions
Family: 120V Series Brick Light Item No. 59040/59009 BZ
THERMAL PROTECTION IS NOT REQUIRED FOR MASONARY OR CONCRETE
POUR INSTALLATIONS. THERMAL PROTECTION IS ALSO NOT REQUIREED FOR
FLUORESCENT LAMPING SINCE RECESSED BRICKLIGHT BALLAST IS CLASS P
AND CONTAINS THERMAL PROTECTION.
Drawing 2 - Fixture Mounting
Drawing 3 - Fixture Mounting
Masonary Wall Installation
1. Install fixture housing (H) into the masonary open hole dedicated for the brick light -
see Drawing 2.
2. Drill two 1/8” pilot holes (4) into each side of the bricks (5) using the two 3/16” holes
(F) in housing (H).
3. Remove the 1/2”NPT plugs (G) from the side and bottom of the housing and pull
supply wires through holes and into housing (H).
4. Leaving 1/8” of housing extended past front of wall, press fixture firmly against the
bricks and thread two 8-32 x 1 3/4” countersunk flat head philips lag screws (5) (not
provided) into the 1/8” pilot holes (4).
5. Please refer back to the front of this sheet to install the lamp and complete
installation of this fixture.
Concrete Pour Installation
1. Level supplied template (F) (refer to second page for template) on wood support
frame (1) (not provided) and drill two 3/16” diameter clearence holes (2). Failure to
level will cause fixture to have tilted appearence - see Drawing 3.
2. Remove the 1/2” NPT plugs (L) from the side and bottom of the housing (K) and pull
the supply wires through the holes and into the housing (K).
3. Be sure all unused electrical plugs have been replaced. Using template (F), cut 1/8”
deep outline into back of wood support (1).
4. Secure housing to wood support (1), with two 8-32 X 1 3/4” wood screws (3) not
provided. Housing (K) must extend 1/8” past front of finished walls.
5. Pour concrete.
6. After concrete is dry, remove two screws (3) and wood support.
7. Please refer back to the front of this sheet to install the lamp and complete
installation of this fixture.
2
3
1. Determine which of the two mounting options are required and refer to the proper
set of instructions below.
H G
5 4 F
1
2
J
L K
1