Billion Electric Company BiPAC 7402G User Manual

Page 47

Advertising
background image

802.11g ADSL2+ VPN Firewall Router

Chapter 4:Configuration

Connect on Demand:

If you want to establish a PPPoA session only when there is a packet

requesting access to the Internet (i.e. when a program on your computer attempts to access the
Internet).

Idle Timeout:

Auto-disconnect the broadband firewall gateway when there is no activity on the line for a

predetermined period of time.

Detail:

You can define the destination port and packet type (TCP/UDP) without checking by timer.

It allows you to set which outgoing traffic will not trigger and reset the idle timer.

RIP:

RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.

MTU:

Maximum Transmission Unit. The size of the largest datagram (excluding media-specific headers)

that IP will attempt to send through the interface.

Advanced Options (PPPoA)

LLC Header:

Selects encapsulation mode, true for using LLC or false for using VC-Mux.

Create Route:

This setting specifies whether a route is added to the system after IPCP (Internet

Protocol Control Protocol) negotiation is completed. If set to enabled, a route will be created which
directs packets to the remote end of the PPP link.

Specific Route:

Specifies whether the route created when a PPP link comes up is a specific or default

route. If set to enabled, the route created will only apply to packets for the subnet at the remote end of
the PPP link. The address of this subnet is obtained during IPCP negotiation.

Subnet Mask:

sets the subnet mask used for the local IP interface connected to the PPP transport. If

the value 0.0.0.0 is supplied, the netmask will be calculated from the class of the IP address obtained
during IPCP negotiation.

Route Mask:

Sets the subnet mask used by the route that is created when a PPP link comes up. If it is

set to 0.0.0.0, the subnet mask is determined by the IP address of the remote end of the link. The class
of the IP address is obtained during IPCP (Internet Protocol Control Protocol) negotiation.

MRU:

Maximum Receive Unit. This is negotiated during the LCP protocol stage.

46

Advertising