Hinkley Lighting VERANDA 4807SU - Manual

assembly instructions
Family: Veranda Item No. 4807 SU
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first partially
assembling the main body of the fixture, installing the required mounting
braces, mounting the mounting strap to the junction box, making all necessary
electrical connections, and then hanging the fixture from the ceiling, and then
completing the assembly of the main fixture.
start here
48
07
1. Thread nipple (A) of center column assembly (2) into coupler (B), located on the
top of the main body assembly (1) - see Drawing 1.
2. Starting with the top 3 arms (E) and spread them apart so they are evenly spaced
120 degrees apart.
3. Spread arms (F) of the second tier apart until they are equally spaced 60 degrees
apart, and are positioned, so that every other arm is between the top tier arms (E).
4. Attach the bottom of arm (F) to the main fixture body (1) using the ball knob
screws (5).
5. The bottom tier arms (G) are to be spread so they are equally spaced 60 degrees
apart and each arm is spaced evenly between the arms of the second tier (F).
6. Attach the bottom of arms (G) to the main fixture body (1) using the ball
knob screws (6).
7. Attach uprights (3) to fixture by placing end (D) over peg (C) and attaching top to
center column assembly (2) using ball knob studs (4) provided. Repeat for remaing
uprights.
8. Please refer to I.S. 19-50 to properly hang fixture from ceiling and continue
installation of this fixture. This fixture is over 50 lbs when fully assembled. In order to
be U.L. compliant, additional support in the ceiling is required.
Drawing 1 - Fixture Assembly
Drawing 2 - Fixture Assembly
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
1. Slip the candle sleeve (7) over the socket (H) - see Drawing 2.
2. Slip shade harp (8) over top of candle sleeve.
3. Set shade (9) on top of shade harp (8).
4. Crystal penatlogs (10) are attached to the by clipping them onto the small
loops provided (J).
C
D
3
4
5
1
6
22
2 A
2 B
9
10
8
7
H
E
F
G
J
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com