Hinkley Lighting CARLTON 4770SH - Manual

assembly instructions
Family: Drake Item No. 4770 AT
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the gull wing bracket - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the back plate (E) - see Drawings 1 and 2.
2. Attach mounting strap (A) to junction box (J) using two 1” screws (C) - see
Drawing 2.
1. Prior to installing glass, fixture can be lamped accordingly.
2. To install glass, slip glass cylinder (1) down into cup (3) - see Drawing 3.
3. Place shade (2) onto top of glass cylinder (1), making sure ring (4) of shade rests
inside the top edge of the glass.
1. Slide backplate (E) over screws (B) and secure with ball knobs (F) - see Drawing 2.
*** The construction of this fixture will be accomplished by first assembling the
main fixture body, installing the mounting strap to the junction box, making all
necessary wiring connections, mounting the fixture to the wall, and then installing
the glass.
start here
4770
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 1 - Strap Detail
Drawing 2 - Fixture Mounting
B
(side view)
gull wing
bracket
backplate
B
Drawing 3 - Fixture Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1
3
2
4
5
2.29.08
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com