Hinkley Lighting BRANTLEY 5363 - Manual

assembly instructions
Family: Brantley Item No. 5362 / 5363
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembl
y.
*** The construction of this fixture will be accomplished by first attaching the
mounting strap to the junction box, making all necessary electrical connections,
assembling the main body of the fixture, mounting the fixture to the wall,
and then installing the glass.
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Assembly
1. To install glass, remove the spacer (3) and socket ring (4) from the socket (1) - see
Drawing 2.
2. Place glass (2) over the socket (1).
3. Slip spacer (3) and thread socket ring (4) back on to socket (1) and hand tighten.
Note: Over tightening could cause damage to glass.
4. Fixture can now be lamped accordingly.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
5
1. Mount the fixture by sliding the back plate (B) over mounting plate (A) - see
Drawing 1
.
2. Attach the back plate (B) to mounting plate (A) with screws (C).
Drawing 1 - Fixture Mounting
3
4
1
2
4.8.10
c
a
f
d
e
g
b
1. Remove mounting screws (f) from backplate (g) - See Drawing 1 .
2. Remove retainer plate (a) from inside of backplate (g).
3. Attach retainer plate (a) to junction box using 2 screws (b).
Additional support can be provided for the retainer plate (a) by installing the plastic wall
anchors (c) and the wood screws (d) in the keyhole slots (e).
5. Make electrical connnections from supply wires to the fixture lead wires. Refer to
instruction sheet (IS-18) and follow all instructions to make alll necessary wiring
connections.
6. To mount fixture, slip the backplate
(g) over retainer plate (a) and thread screws (f )
into top and bottom of backplate (g) to secure fixture to wall - See Drawing 1.
5362 5363
Start Here
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com