Hinkley Lighting TITAN 2050 - Manual

assembly instructions
Family: Titan Item No. 2050 HE/KZ/TT
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
1. Prepare mounting strap (A) by threading the two 1 1/4” long mounting screws (B)
into the back of the gull wing bracket - see Drawing 1.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the back plate (E) - see Drawings 1 and 2.
2. Attach mounting strap (A) to junction box (J) using two 1” screws (C) provided - see
Drawing 2.
3. Take assembled fixture and locate barrel knobs (5) at bottom of cage assembly (2) -
see Drawing 3.
4. Unthread barrel knobs (5) and set aside to be used later.
5. Lift bottom of cage assembly (2) until it clears the mounting studs (4).
6. Push up on cage assembly (2) to disengage keyhole slot (3) from anchor knob (6) at
top of cage assembly (2). Set cage assembly (2) aside for re-assembly later.
1. To install glass, thread cylinder glass (1) into glass holder (7) attached to backplate
(E) - see Drawing 3.
2. Fixture can now be lamped accordingly.
3. To attach cage assembly (2) to backplate (E), slip keyhole slots (3) over anchor knob
(6) located at the top of backplate (E).
4. Slip mounting stud (8) located at bottom of backplate (E) into hole (4) located in the
bottom of cage assembly (2).
5. To secure cage assembly (2) to backplate (E), thread barrel knob (5) onto end of
mounting stud (8) and tighten.
*** The construction of this fixture will be accomplished will be accomplished
by first mounting the mounting strap to the junction box, making all necessary
electrical connections, mounting the backplate to the wall, installing the glass,
and then attaching the cage assembly.
start here
2050
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Note: Maximum wattage for 2050 fixture is 100 watts per bulb.
Drawing 1 - Strap Detail
Drawing 2 - Fixture Mounting
B
(side view)
gull wing
bracket
backplate
B
Drawing 3 - Fixture Assembly
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections. Then
refer back to this sheet to continue installation of this fixture.
11
8
7
E
2
4 5
3
1. To mount fixture to the wall, slide backplate (E) over screws (B) and secure with ball
knobs (F) - see Drawing 2.
5
4.19.10
6
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com