Hinkley Lighting REVERE 1184SN - Manual

Drawing 1 - Fixture Mounting
Drawing 2 - Fixture Assembly
star t here
1. To prepare fixture for mounting, unthread decorative knobs (G) from front of the
backplate (A) and remove retainer plate (F) from the inside of the backplate - see
Drawing 1.
2. Determine which knockouts (D) willl have to be remoed to mount retainer plate (F)
vertically to the junction box (C).
3. Attach retainer plate (F) to the junction box using screws provided.
assembly instructions
118
4
2
3
4
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to instruction
sheet (I.S. 18) and follow all instructions to make all necessary wiring connections.
Then refer back to this sheet to continue installation of this fixture.
1. Mount the fixture by slipping the holes (B) in the back plate (A) over mounting
studs (H), make sure to tuck wires inside backplate carefully making sure not to pinch
them - see Drawing 1.
2. Hold fixture in position and thread decorative knobs (G) removed earlier to secure
fixture.
3. It is recommended to run a bead of silicone around the backplate where it contacts
the house in order to seal it from the weather.
Note: Maximum wattage for 1184 fixture is 60 watts per bulb.
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first installing the
glass, mounting the mounting strap to the junction box, making all necessary
electrical connections, and then mounting the fixture to the wall.
Family: Revere Item No. 1184
5.18.10
B G
D
E
H
E
F
A
C
25
21
23
22
24
1. To install glass, open side door (not shown on drawing 2) of fixture by lifting up on
the small wire tab located on the right side of the fixture when looking at it straight on
- see Drawing 2.
2. Install back panel of glass (1) on left side of fixture by slipping the glass into the
cage through the door opening (2) at a slight angle and behind the socket (3) and into
position.
3. Fold glass clips (4) located at the top and bottom of the cage so they contact the
glass and hold it in position.
4. Repeat procedure for front panel of glass. Now slip side panel on far side of cage
around sockets and into position. Folding glass clips down to secure glass.
5. When all glass panels are installed, the candle sleeve (5) can be slipped over socket
(3).
6. Fixture can now be lamped accordingly.
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com