Hinkley Lighting GENTRY 3473PB User Manual

Start here, Assembly instructions

Advertising
background image

____

Assembly Instructions

____

Item No. 3472 / 3473

1. Find a clear area in which you can work.

2. Unpack Fixture and glass from carton.

3. Carefully Review Instructions Prior to assembly.

***

The construction of this fixture will be accomplished by first assembling the

main body of the fixture, attaching the mounting strap to the junction box,

making all necessary electrical connections, hanging the fixture from the

ceiling, installing the shade, and then installing the glass lens.

1. Prepare mounting strap (B) for mounting by installing screws (A) into mounting

plate (B) - see Drawing 1.

• Be sure the holes into which the screws are threaded match the spacing of holes (C)

in the canopy (1).

2. Attach mounting plate (B) to junction box (J), using screws (G) provided and slip

supply wires through large center hole.


SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.

1. Hang the fixture by slipping the mounting holes (D) in the canopy (1) over screws (B),
mounted in strap (A) previously - see Drawing 2.

2. Thread ball knobs (E) onto end of screw (B) and tighten to secrure fixture.

J

B

A

G

E

C

D

07.12.05

start here

3472

H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com

Drawing 1 - Mounting Detail

Drawing 2 - Glass replacement

4

1

3

2

5

GLASS REPLACEMENT INSTRUTCTIONS:

1. It is recommended that the fixture be take down from the ceiling prior to replacing
the glass - see Drawing 2.

2. To replace glass first remove tear drop knobs (1) from bottom ring. Caution: if fixture
is installed when knobs are remove there is a possibility that all the glass could fall out.

3. Remove bottom ring (2), then remove rubber washers (3).

4. Slip glass (4) from between the uprights (5).

5. Replace glass (4) and re-assemble fixture by following step 1-3 in reverse order

2

3

4

1

3473

Advertising
This manual is related to the following products: