Hinkley Lighting TRUMAN 4021AN - Manual

assembly instructions
Family: Truman Item No. 4021
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the glass.
start here
4021



SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Drawing 2 - Fixture Assembly
01.01.12
Drawing 1 - Fixture Assembly
1. Rotate arms (1) attached to canopy, until they are equally spaced 120
degrees apart - see Drawing 1.
2. Attach ring (2) by lining up the three holes (B) in the ring with the 3 holes (C) in
the arm (1) and threading in the flat head phillips screws (3) to secure ring - see
Drawing 2.
1
1
Drawing 5 - Glass installation
2
3
5
4
9
8
D
7
6
B
C
1
2
3
10
9
11
3
4
NOTE: Fixture can be lamped accordingly prior to glass installation.
1. To install glass, thread tube (4) into coupler (D) approximately 3/8”, making sure
hex nut (5) on the tubing is near coupler - see Drawing 5.
2. Tighten hex nut (5) against coupler (D) to secure tube (4).
3. Slip glass (6) onto fixture and up against ring (2) and hole in position.
4. Slip rubber washer (7) followed by steel washer (8) over tube (4), and hold in
position.
5. Thread hex nut (9) onto tube (4) and tighten to secure glass (6).
6. Slip cap (10) onto tube (4), and then thread finial (11) onto end of stem (4) and
hand tighten only, to complete assembly.
Drawing 4 - Fixture Mounting
Drawing 3 - Strap Detail
J
B
G
D
C
E
A
1. Install screws (A) into mounting plate (B) - see Drawing 3.
• Be sure the holes into which the screws are threaded match the spacing of holes (D)
in the canopy (E) - see Drawings 1 and 2.
2. Attach mounting plate (B) to junction box (J), using screws (G) provided and then slip supply
wires through large center hole.
1. Hang the fixture by slipping canopy (D) over screws (B) in the mounting strap - see Drawing 4.
2. Thread on ball knobs (E) onto the end of screws (B) and tighten to secure fixture to ceiling.
5
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com