Hinkley Lighting BURIAL BALLAST BOX 53000 - Manual

H I N K L E Y L I G H T I N G 12600 Berea Road Cleveland, OH 44111 800.446.5539 / 216.671.3300 www.hinkleylighting.com
installation instructions
Family: 120V Series Large Burial Box Item No. 53000 BZ
1. Find a clear area in which you can work.
2. Carefully review instructions prior to assembly.
3. Gather tools required: WIRE STRIPPERS, PHILIPS HEAD SCREWDRIVER,
SHOVEL, TEFLON TAPE, THREAD SEALANT, AND PIPE SEALER.
• Save these instructions for future reference.
start here
53000
WARNING: COMPOSITE IN GROUND BALLAST MUST BE INSTALLED AND
GROUNDED IN ACCORDANCE WITH THE NATIONAL ELECTRICAL CODE (NEC) AND
LOCAL CODES. FAILURE TO DO SO MAY RESULT IN SERIOUS INJURY AND/ OR
DAMAGE TO THE LUMINAIRIES AND IN GROUND BALLAST BOX.
ALWAYS USE UL RECOGNIZED WIRE CONNECTORS FOR CONNECTIONS.
IN GROUND BALLAST BOX IS ETL LISTED FOR BELOW GRADE INSTALLATION ONLY.
1. To prevent electrical shock, disconnect from the electrical supply before servicing.
2. Dig hole approximately 14” deep by 12” diameter - see Drawing 1.
3. Install conduit (1) not provided through bottom hole (A) in bottom of ballast box
(B), using Teflon tape or other thread sealant not provided.
• Position ballast box top cover (C) to protruded above grade to allow for cover removal.
• UL listed flexible conduit (1) (not provided) is recommended for in and out connections
to ease fixture position and adjustment during installation.
• For a more secure installation, rebar bracing is recommended. Drill a hole for a 1/4”
bolt and nut in two of the stiffeners (3) - see Drawing 2 on reverse side - located on
the side of the luminaire. Attach perforated strap (plumbers tape) (not provided) to the
drilled holes with 1/4” nuts and bolts not provided.
4. Please refer to the back of this sheet for instructions on how to seal the wire
compartment and complete installation of this fixture.
Use with the following fixtures:
Info 54000 BZ: Lamp Type is R20, R40, PAR20, PAR 38.
Maximum Wattage is 50 watts per bulb.
Info 55000 BZ: Lamp Type is Metal Halide, Medium Base.
Maximum Wattage is 175 watts per bulb.
A B
C
1
Drawing 1 - Fixture Mounting
3.4.08