Hinkley Lighting NEST FR52204ORB - Manual

FR52204ORB
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first installing the mounting strap to
the junction box
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring
is required, consult a qualified electrician or local authorities for code requirements.
STEP 2
1 Remove ball knobs (c) from fixture - See Drawing 2.
2 Remove retainer plate (a) from backplate (d).
3 Attach retainer plate (a) to junction box (j) using screws (b).
4 Additional screws (not provided) can be installed at points (e).
5 Make electrical connections from supply wire to fixture lead wires. Refer to
instruction sheet
[FRIS18] and follow all instructions to make all necessary
wiring connections. Then refer back to this sheet to continue installation of
this fixture.
6 Slip holes (g) in backplate (d) over screws (f) on retainer plate (a).
7 Thread ball knobs (c) onto screws (f) and tighten to secure backplate to wall.
[DRAWING 2]
Bulbs: 75 W MED. Replacemnt parts:
GLASS : R52204GL-FRT, R52204GL-BOT, R52204GL-END
01.01.10
800.421.3517 WWW.FREDRICKRAMOND.COM
b
e
c
g
d
f
a
NEST
, installing the glass, then mounting the fixture to the wall.
STEP 1
1
2
3
4
[DRAWING 1 ]
2
The glass must be installed in a specific order. The first panel to
install in the fixture is the bottom panel (1) - See Drawing 1. It will be
necessary to navigate the panel passed the sockets. This can be
accomplished by slipping the back edge of the panel under the sockets
and then lowering the front edge of the glass down into positon.
Intall the tow side panels (2) next. Slip this down into position behind
the glass clips (3) located on the front upright (4) and backplate (5).
Now slip the front arched panel (6) behind the glass clips (3) located on the
front uprights.
Bend glass clips (3) against glass to hold panels in position.
2
1
3
4
5
6