Hinkley Lighting BIJOU FR43536PNI - Manual

FR43535 /43536 / 43538
BIJOU
ASSEMBLY INSTRUCTIONS
Assembly of this fixture will be accomplished by first assembling the main body of the
fixture, attaching mounting hardware to the junction box, making all neccesary electrical
connections, and then hanging the fixture from the ceiling.
SAFETY WARNING: Read wiring and grounding instructions [FRIS 18]
and any additional directions. Turn power supply off during installation. If new wiring is
required, consult a qualified electrician or local authorities for code requirements.
[DRAWING 2]
[DRAWING 3]
Bulbs: 60W CAND.
STEP 1
1. It is first necessary to asembly the main body of the fixture, this is acomplished by
taking the arm assemblies (a) and attaching them to the center column assembly
(b) - see Drawing 1. This is accomplished by first inserting lower arm tab (lt) into
lower slot of center column assembly (ls) - see Drawing 1 and 2, and installing the
upper arm tab (ut) into upper body slot (us) of center column assembly (b) - see
Drawing 1 and 3. Repeat process for until all arm assemblies are installed.
2. Next it is necessary to lock the arm assemblies (a) in position. This is accomplished
by slipping locking cap (1) along wire and onto center stem (2) at top of center
column and making sure the slots (s) in the locking cap (1) slide over upper arm tabs (ut)
- see Drawing 3.
3. Thread hex nut (3) onto center stem (2) and tighten down onto locking cap (1) to
secure arms (a) onto center column assembly (b).
4. Slip upper body cap (4) along wire and into upper body. Next slip loop (5) along
wire and thread onto center stem (2) and tighten to complete fixture assembly.
5. Fixture can be installed at this time, please refer to hanging instruction sheet
[FRIS19-50R] provided.
[DRAWING 1]
a
b
b
lt
ls
ls lt
ut
us
ut
us
a
b
5
4
3
1
s
2
01.01.13