Hinkley Lighting CASA 4016OL - Manual

assembly instructions
Family: Gasa Item No. 4016 OL
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the main body of the
fixture, installing the mounting hardware, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the glass.
star t here
4016
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
CAUTION: The supply wire of this fixture has been laced through one of the uprights (part 2 on
drawing 1) for your convience. Please use caution when assembling the fixture to prevent wire
damage. It is advisable to layout the fixture on a floor and assemble the main body prior to
installation.
1. To assemble main body, take upright (2), with the supply wire running through it, and hook the
lower upright scroll (B) under the ring scroll (A). Making sure not to pinch the wire.
2. Repeat step 1 for the remaining 3 uprights.
3. Take the top of upright (2) and hook loop (D) over hook (C).
4. Please refer to the hanging instruction sheet (I.S. 19-75) provided to hang fixture. Then refer back
to this sheet to install glass.
1. To install glass, remove socket ring (4) from socket (E).
2. Slip glass (5) over socket (E). See Drawing 2
3. Thread socket ring (4) onto socket (E) to retain glass (5).
4. Repeat steps 1-3 for remaining glass.
5. Fixture can now be lamped accordingly.
Drawing 1 - Body Assembly
B
2.7.08
A
C
D
Drawing 2 - Glass Installation
2
4
E
5
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com