Hinkley Lighting TRUMAN 4025AN - Manual

assembly instructions
Family: Truman Item No. 4025
1. Find a clear area in which you can work.
2. Unpack fixture and glass from carton.
3. Carefully review instructions prior to assembly.
*** The construction of this fixture will be accomplished by first assembling the
main body of the fixture, making all necessary electrical connections, hanging
the fixture from the ceiling, and then installing the fixture glass.
start here
40
25
Drawing 1 - Assembly
Drawing 2 - Glass Installation
SAFETY WARNING: READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18)
AND ANY ADDITIONAL DIRECTIONS. TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED
ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
72 degrees
apart





1. To assemble main body, spread arms (A) located on the main body assembly (1), until
they are equally spaced 72 degrees apart - see Drawings 1 & 2.
3. Please refer to the hanging instruction sheet (I.S. 19) provided to hang fixture. Then
refer back to this sheet to install glass.
01.1.12
2. Next slip loop (L) along wire and thread onto tube (T) located at the top of the fixture.
1. to install glass remove socket ring (1) followed by spacer (2) from socket (B).
2. Slip glass (3) over socket (B).
3. Siip spacer (2) over socket, and thread socket ring (1) onto socket to secure glass.
4. Fixture can now be lamped accordingly.
5. Fixture is complete.
L
T
1
2
B
3
A
H I N K L E Y L I G H T I N G 33000 Pin Oak Parkway Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkleylighting.com